Cycle Kart engine

[Tony Sanchez]

---I have found a supply of 6.5 hp 200 cc Honda GX clones. I think they are chinese engines, new still in box. $225.00 while they last.
---Tony.

[Tony Sanchez]

---I have found a supply of 6.5 hp 200 cc Honda GX clones. I think they are chinese engines, new still in box. $225.00 while they last.
---Tony.

[Tinman]

Hello Tony
I would like to have one of those motors. I'll e-mail you to find out if you still have them.
Tinman

[goleafsgo_12]

ya me 2, oculd you PM me with some details?

Thanks, Ryan.

[Tinman]

Tony
I think I have a problem! The shaft size of the motor is .786" or 2 centimeters. Comet clutches come only in .750" or 3/4" the drive shive on the clutch is a extruded piece. Got any suggestions.
Tinman

[goleafsgo_12]

really? Thats a really wierd crank size, get it turned down to 3/4" on a lathe.

[ralph]

Tinman,
The comet clutches are also available with a 1" bore, so you could run a sleeve.
You can find their webpage and tech info here
http://www.hoffcocomet.com/

[Tinman]

Thanks Ralph
That was a good suggestion I might turn one out tomorrow.

[Tony Sanchez]

---John sorry I couldn't get back to you any sooner, I have been out of the country for three weeks. Had no access to the internet.

I just measured the engine that I have and it measures .750. I'll get in touch with the importer and see why there is a difference.

---Tony.

[Kerry Pinkerton]

Hi Tony, Are you in any risk from the wildfires? My other buddy in Temecula got evacuated but apparently they saved his house and we assume his 30 Packards and Imperials.