|
|
|||||||
| General metalshaping discussion Wide ranging discussions, with the focus always on metalshaping. |
|
|
Thread Tools | Display Modes |
|
#1
05-03-2012, 12:36 PM
|
|||
|
|||
Cant find what I need!
Alright guys I need to make the lower section of a door skin for a 56 ford pick up, I think it's 18g tho I'm not 100% sure all I can find around here is 16g. I'm thinking this might be too thick. I haven't had a chance to measure the thickness. Does anyone know off hand what gauge it is? Iv been calling everywhere and coming up with nothing. Any ideas? Thanks
Ryan 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode