savage 336

[dropgate]

hi,

I just purchased a savage power nibbler i am going to retro fit shrinking dies to and was wondering if anyone out there has had any experience with the savage. I know the pullmax is real popular to do this with and I have seen some dies for the savage on the net but can't find much info on it. If anyone has any words of wisdom i'm listening.

Thanks, Chad

[SecaTim]

Chad,
I noticed that you list location as BattleCreek is that as in Michigan?

Tim 8)

[dropgate]

secatim

yes, that is BattleCreek, Michigan

[Richard K]

Do you have any photos you cpuld post?

[dropgate]

Richard

i'm new to this and any forum so I will have to take a few minutes in the tutorial section to figure out how to set up an album and attatch a picture to my post. I have to go pick the unit up tomarrow but I do have a Picture I printed off, It's not great but i will try to put it on

Chad

[dropgate]

hi,

It took me a little time but I think I figured it out. So here is a pictrue of the savage 336 It has a 36" throat and a 2 horse three phase motor

http://www.metalmeet.com/photopost/data/500/1509savage.bmp?1492