novest sheet metaler

[tommy5344]

Hi,,,,i have a driver 53 chevy im making look better then when i bought it, there are some corners near the doors,i have to make,maybe i can get some ideas,thanks,,

[Tisdelski]

hi tommy,
welcome to metalmeet. post a picture of the spot you need to make so we all know what needs to be done. if you don`t know how to post a pic. just ask , lots of people can describe how to do it.

gary

[roger n cindy]

welcome tommy, you have arrived at the right destination if you desire to shape metal. do a search first then post some pictures and ask some questions. your profile doesn't say where your from , a lot of guys don't, but if your anywhere stlouis mo. we have a couple of regional meets every year you might consider for some hands on ! search rebel meet and april fools meet.

roger, president and ceo Bugly tool and services.

at Bugly we cut down the cost, by stealing from the other guy to pass the savings on to you.

[roger n cindy]

PS , do a search on this site for "53 chevy". Brandon is building a 53 as we read.
roger

[edwardd_]

Oh, Roger,

Your staff has yet to post the event in the MM Calendar!

:lol:

http://toolandfab.com/forum/images/smilies/more/lol.gif

http://toolandfab.com/forum/images/smilies/more/OLA.gif

[roger n cindy]

thanks david, i didn't realize that the staff had not completed that small task. lets blame it on middle management ! you would think that in an outfit that has representatives in fewer than 17 countries with fewer than 1,600 employees the president and ceo would not have to lift his finger to type ???? i however have rectumfied that situation.
roger, president and ceo Bugly tool and Services.

our research department has spied a few good ideas so watch for a new load of B.S. from Bugly.