.401 Shank Upper Dies

[Joe Andrews]

Removed by Joe Andrews

[Oldtin]

Joe, The dies look great!
Are you planning to offer different radius dies?
How about some directionals with an index of some sort?
How much are they?
If you had an assortment with different radius we could use them for both lowers and uppers in our homade hammers.

Les Edmundson

[rookie]

You guys ROCK! That's a hell of a finish on those dies. When are you planning to arive at MM, Joe? I want to grab a set of lower anvils while you have them.

Thanks, and great job!, Phil Gilmore (rookie)

[Tony Sanchez]

---Joe, Your dies look great. Are you still making UHMW lower anvils?
---Tony.

[Boogiemanz1]

Joe, your stuff looks killer as usual..........john

[Nortonscustom]

Joe,
Your timing couldn't have been better! I just completed a zip gun based planishing hammer yesterday and was going to order the steel for the upper hammer today. But now I can just order one from you, and I'll be making ridiculous amounts of noise in less than half the time. Thanks buddy!

norton