View Full Version : Metalshaping tricks #2
08-13-2012, 09:44 PM
Hi all, I got a email about my second video, that told me that it was hard to find the link to it becouse I put it up under the thread about the first video...
So here we go again :)
hope it light up some ideas for you!
Thanks for your time :-)
08-14-2012, 02:21 AM
This looks like a good place to "stack em in one place".. start a library with your videos.
The "watch free videos" area.. If you and a admin want to move them there.. otherwise videos will be "scattered as if I did it".
(not had my coffee yet.. I needed a clothes wringer when I got home last night, it was at least warm rain.. like pee down your back)
Off to make the coffee..
08-14-2012, 09:22 AM
Per, I will start a new thread in the Free video's subforum it will contain a link to you page on you tube. Thanks for sharing and not having "abba" as the music:rolleyes:
vBulletin® v3.8.6, Copyright ©2000-2013, Jelsoft Enterprises Ltd.